Outboard motor lifting handle - prototype.

Clyde_Wanderer · Post by **Clyde_Wanderer** » Wed Oct 29, 2008 9:58 pm

I am not sure if I would trust those plastic snap buckles to take the weight of a 6hp motor.
All the same, it does look a good bit of kit.
Where will they be available from on release?

Post by **Silkie** » Wed Oct 29, 2008 10:13 pm

Clyde_Wanderer wrote:Where will they be available from on release?

Clyde_Wanderer · Post by **Clyde_Wanderer** » Thu Oct 30, 2008 11:27 pm

Silkie wrote:
Clyde_Wanderer wrote:Where will they be available from on release?

?????????

Post by **Silkie** » Fri Oct 31, 2008 12:07 am

Sorry, I thought you were joking, making out you didn't know that JohnS would be flogging them from his own site.

Obviously I'm holding the wrong end of the stick again.

Post by **Silkie** » Fri Oct 31, 2008 6:42 pm

JohnS wrote:And I thought it was a joke based on the suspected unplanned release of the snap buckles!

That too, of course.

BLUEMOMENT

Outboard motor lifting handle - prototype.

Re: ???????