I am taking the paint right off my keel - right back to the bare cast iron. To protect the cast iron I want to put some kind of epoxy on before International Primocon, then antifouling.
Is International Epiglass suitable for this, or if not, what is suitable?
(Previously the YotBlog forums, now archived and combined here)
2 posts • Page 1 of 1
- Bodach na mara
- Master Mariner
- Posts: 139
- Joined: Wed Jan 21, 2009 12:54 am
- Boat Type: Westerly Seahawk
- Location: Clyde
I would have thought VC Tar Epoxy would be more suitable Pete. I have used it on my keel. I still get little rust spots where the coating has not been adequate, but I did not do the original job (excuses, excuses) and found it difficult to get the keel completely clean of antifouling as the casting is a bit rough.
Who is online
Users browsing this forum: No registered users and 1 guest