Mk1 Harken furler foil or small part thereof

Post your boaty wants here
User avatar
Old Salt
Posts: 922
Joined: Sat Jul 31, 2010 9:40 pm
Boat Type: Rival 32
Location: West Lothian

Mk1 Harken furler foil or small part thereof

Postby mm5aho » Wed Nov 04, 2015 9:35 pm

I need a new lower section of the foil on my Harken Mk1 furler. This aluminium extrusion is the part below the entry bracket for the sail bead, and is about 750mm long, so I'm looking for perhaps a metre of this extrusion to fashion a replacement. Mine is worn at the point where it is driven by the drum. In the Mk1 the drum drives direct onto the foil, with a small clamp, but can tend to wear the foil where it enters the drum. I need to remove about 25mm, so be better to replace that bit.
Anyone got a scrap foil, or part of one?
"Contender" Rival 32: Roseneath in winter, Mooring off Gourock in summer.

User avatar
Admiral of the White
Posts: 1982
Joined: Thu Jan 03, 2008 8:17 pm
Boat Type: Marcon Claymore
Location: Clyde

Re: Mk1 Harken furler foil or small part thereof

Postby sahona » Mon Nov 09, 2015 11:57 pm

Perhaps a pic of the cross section of the extrusion would help. I've got a dod of Bamar foil in stock just in case there's an incident. 20' - 30' Berths available, Clyde.
Cruising, racing, maintenance facilities. Go take a look, you know you want to.

Return to “Stuff Wanted”

Who is online

Users browsing this forum: No registered users and 1 guest